Five tips for using stone cutting machinery

Five tips for using fiber laser cutting machine
1) The dual focal length laser cutting head is a vulnerable item on the laser cutting machine, and long-term use will cause damage to the laser cutting head.
2) Check the straightness of the track of the fiber laser cutting machine and the verticality of the machine every six months, and maintain and debug it in time if it is found to be abnormal. If you don't do this, it is possible that the cutting effect will not be very good, and the error will increase, which will affect the cutting quality. This is the most important thing, it needs to be done.
3) Use a vacuum cleaner once a week to suck off the dust and dirt in the machine, and all electrical cabinets should be closed tightly to prevent dust.
4) Always check the steel strip of the fiber laser cutting machine to ensure that it is tightened. Otherwise, if there is a problem during operation, it may injure people, and in serious cases, it can lead to death. The steel belt seems to be a small thing, but the problem is still a bit serious.
5) Each guide rail of the fiber laser cutting machine should be cleaned frequently to eliminate dust and other debris, and the rack should be wiped frequently to ensure the normal operation of the equipment, and lubricating oil should be added to ensure lubrication without debris. The guide rail should be cleaned and lubricated frequently, and the motor should also be cleaned and lubricated frequently, so that the machine can move better and cut more accurately, and the quality of the cut product will be improved.

Precautions
The precautions for operating the laser cutting machine are as follows:
1. Comply with the general cutting machine operating procedures. Start the laser, dimming, and test machine in strict accordance with the laser start-up procedure.
2. The operator must be trained, familiar with the cutting software, equipment structure and performance, and master the relevant knowledge of the operating system.
3. Wear labor protection equipment according to the regulations, and wear protective glasses that meet the requirements in the laser beam.
4. Do not process a material until it is clear whether it can be irradiated or cut with a laser, so as to avoid the potential danger of smoke and vapor.
5. When the equipment is started, the operator shall not leave the post or entrust someone to take care of it, and if it is really necessary to leave, it should be stopped or cut off the power switch.
6. When an abnormality is found in the processing process, the machine should be stopped immediately, and the fault should be eliminated in time or reported to the supervisor.
7. Keep the fire extinguisher within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth, or other flammable materials near unprotected laser beams.